Features of DX-SR8T/E
- Coverage of All short-wave and HF amateur bands
(DX-SR8T North American /DX-SR8E European and other regions)
Covers the 160m to 10m amateur bands including 5.3MHz (T-model only) in
SSB, CW, AM and FM modes. Output power is 100W SSB/CW and FM, 40W in AM
with low and super-low power settings for QRP operation. In addition,
the general coverage receiver covers 135KHz to 30MHz in all modes.
- Detachable front control panel
Remove front control panel with large LCD display allowing you to install the radio with greater flexibility anywhere including your car, boat
or your shack. (Optional EDS-17 cable required)
- Direct DATA entry via the key pads
While the main dial tunes at the default 10Hz/resolution (adjustable in
set mode), the numerical key pads can be utilized for fast direct frequency
input, band selection and more.
- Fight QRM with these STANDARD features
Feel free to reject unwanted signals with the IF shift. Choose among a narrow filter, a noise-blanker or use RIT/TXIT to stay out of QRM.
- Emphasis on CW Operation
An electronic keyer unit is standard. You're able to receive CW using either
upper or lower side of the carrier frequency. Choice of side tone pitch,
FULL (QSK), Semi or Auto break-in, split, narrow filter, AGC and RF
gain.
- World-class transmit audio quality
A dynamic microphone (T/E models) and a speech compressor come standard for sharp, clear and powerful transmitting audio.
- Enhanced scan modes
Numerous scan modes are available including Priority, Search, Busy,
Timed, Memory and Programmed search. Timed scan setting does not require
squelch-mute allowing you to monitor data-modes and broadcasts
simultaneously with memory search scan.
- Additional convenient features include
RF Attenuator and Pre-amplifier selectable in 4 steps, / 3 TX power
output levels with a Super-Low setting (QRP 0.1W~2W variable) / Dual
VFO / 600ch memories in 3 banks / Connections for Auto-antenna tuner and
Liner amplifier ALC output / Fully independent AF level, squelch, RIT
and IF shift knobs / Dial lock and key lock / TX-RX lamp / Alphanumeric
display / Auto-power-off / CTCSS encode for 10m FM repeater accesses /
Microphone, Headphone and External speaker jacks on the front panel /
Large, temperature-controlled internal cooling fan with anti-overheat
output power limiter/ High-SWR protection?cand more!
[Standard accessories]
- EMS-64 (SR8E/SR8T: Dynamic)
- DC cable
- Microphone hanger EBC-7
Power Supply Available
Download the Instruction Manual Now
Specifications:
GENERAL
Operating mode: J3E (USB, LSB), A3E (AM), A1A (CW), F3E (FM)
Antenna impedance:
50ohm unbalanced
Frequency stability:
+/-1ppm
Power requirement:
13.8V DC +/-15% (11.7 to 15.8V DC)
Ground method:
Negative ground: Current drain
Receiver: 1.0A(max.) 0.7A(Squelched)
Transmit: 20A
Operating temperature:
-10digC to 60digC (+14digF to +140digF)
Dimentions: 240(w) x 94(h) x 255(d)mm (Projections not included)
(9.45"(w) x 3.7"(h) x 10"(d)
240(w) x 100(h) x 293(d)mm
(9.45"(w) x 3.94"(h) x 11.54"(d)
Weight: Approx. 4.1kg (144.6oz)
TRANSMITTER
Power Output: SSB, CW, FM: 100W(Hi) Approx. 10W (Low) Approx. 1W (S-Low)
AM: 40W(Hi) Approx. 4W (Low) Approx. 0.4W (S-Low)
Modulation system: SSB: Balanced modulation
AM: Low power modulation
FM: Reactance modulation
Spurious emission: Less than -50dB (Less than -45dB in 30m band)
Carrier suppression: More than 40dB
Unwanted sideband: More than 50dB(1KHz)
Maximum FM deviation:
+/-2.5KHz
RECEIVER
Receive circuitry:
Double conversion superheterodyne
Sensitivity: SSB: (0.15 to 1.8MHz) 0dBu(1uV)
CW: (1.8 to 30MHz) -12dBu(0.25uV)
AM: (0.15 to 1.8MHz) +20dBu(10uV)
AM: (1.8 to 30MHz) +6dBu(2uV)
FM: (28 to 30MHz) -6dBu(0.5uV)
Intermediate frequency: 1st 71.75MHz, 2nd 455KHz
Selectivity: SSB, CW, AM(narrow): 2.4KHz/-6dB 4.5KHz/-60dB
AM, FM: 6KHz/-6dB 18KHz/-60dB
-6dB: 6KHz or more
-60dB: 16KHz or less (NFM)
Spurious and image rejection ratio: More than 70dB
Audio output power:
More than 2.0W(8ohm 10%THD)
RIT variable range: +/-1.2KHz